焦化發電機組進水的原因

Reasons for water ingress in coking power generation units

　　在正常使用過程中，可能會由于各種原因導致焦化發電機組進水，下面就來為您講解下。

During normal use, there may be various reasons that can cause water to enter the coking generator set. Below is an explanation for you.

　　溫馨提示，焦化發電機組進水后是不能繼續使用的，因為水是無法被壓縮的，油水混合進入到汽缸后，發動機依然還牌調整運轉期間，做功的過程中不能對水進行壓縮，從而導致活塞卡死，汽缸磨損情況會變得加劇，如果焦化發電機組中有水，除了會導致焦化發電機組發電機組運轉緩慢且不穩定之外，甚至還可能造成曲軸彎曲等，對焦化發電機組發電機組的正常運行帶來非常嚴重的影響。

Kind reminder, the coking power generation unit cannot continue to be used after water ingress, because water cannot be compressed. After the mixture of oil and water enters the cylinder, the engine still needs to be adjusted during operation. During the process of doing work, the water cannot be compressed, resulting in piston jamming and increased cylinder wear. If there is water in the coking power generation unit, it may not only cause slow and unstable operation of the coking power generation unit, but may also cause crankshaft bending, which has a very serious impact on the normal operation of the coking power generation unit.

　　1、由于燃油箱沒有清洗干凈，只要清洗干凈了就基本不會出現進水現象。

1. Due to the fuel tank not being cleaned thoroughly, as long as it is cleaned thoroughly, there will be basically no water ingress.

　　2、油品有問題，建議用戶到正規加油站購買的焦化發電機組，從私人或無資質的企業購買的便宜燃油極可能混有過多雜質或水分。

2. If there is an issue with the oil, it is recommended that users purchase coking generator sets from regular gas stations. Cheap fuel purchased from private or unqualified enterprises may contain too much impurities or moisture.

　　3、燃油箱只有兩個口，一個焦化發電機組機和燃油箱連接的是高壓油泵，一般不可能是發動機出問題這邊的水回流。另一個入口就是燃油箱加油口，如果燃油箱處于室外，是很有可能雨水滲入燃油箱內部。

3. The fuel tank has only two ports, and a coking generator unit is connected to the fuel tank by a high-pressure oil pump. It is generally impossible for the water to return due to engine problems. Another entrance is the fuel tank filling port. If the fuel tank is outdoors, it is very likely that rainwater will seep into the interior of the fuel tank.

　　一般發生焦化發電機組發電機組焦化發電機組進水后，要盡快把電瓶負極線拆下來，以免焦化發電機組發電機的控制系統因時水而發生短路，同時按正確步驟更換燃油濾清器，如果焦化發電機組進水不是很多，可以先讓焦化發電機組靜置一段時間，讓水慢慢沉淀下去，等到水和焦化發電機組成分層后，再將水排凈即可，而如果是進水的量比較大，則應將原有的變質焦化發電機組全部更換，否則可能會造成機組運行冒白煙或運行無力。

Generally, after water enters the coking generator set, the negative electrode wire of the battery should be removed as soon as possible to avoid short circuits in the control system of the coking generator set due to water. At the same time, the fuel filter should be replaced according to the correct steps. If there is not a lot of water entering the coking generator set, the coking generator set can be left to stand for a period of time to allow the water to slowly settle down. After the water and coking generator form a layer, the water can be discharged completely. If the amount of water entering is relatively large, the original deteriorated coking generator set should be replaced completely, otherwise it may cause white smoke or weak operation of the unit.

　　各種原因導致焦化發電機組進水就不能繼續使用了，這一點要多加注意！

Due to various reasons, the coking power generation unit cannot continue to be used due to water ingress, and this requires extra attention!

以上就是有關：焦化發電機組  的介紹，想了解更多的內容請點擊：http://m.hdlelisa.com 我們將會全心全意為您提供滿分服務，歡迎您的來電！

The above is an introduction to coking power generation units. For more information, please click: http://m.hdlelisa.com We will wholeheartedly provide you with full score service. Welcome to call us!