所用焦化發電機組的散熱非常重要，但是隨著運行時間的增加和操作不當，焦化發電機組的散熱器會出現故障。主要是空氣中的水分導致散熱器腐蝕，加速散熱器老化，導致機組散熱器失效。怎么做？

The heat dissipation of the coking generator set is very important, but with the increase of operation time and improper operation, the radiator of the coking generator set will fail. It is mainly the moisture in the air that causes the radiator corrosion, accelerates the aging of the radiator, and leads to the failure of the unit radiator. How do you do it?

1、焦化發電機組散熱器不宜處于局部注水狀態，否則會加速腐蝕。

1. The radiator of coking generator unit should not be in local water injection state, otherwise it will accelerate corrosion.

對于不工作的焦化發電機組，應將所有水抽出或完全充滿。如果可能，請使用蒸餾水或天然軟化水和適量的防銹劑。

For the non working coking generator set, all water shall be pumped out or completely filled. If possible, please use distilled water or natural softened water and an appropriate amount of rust inhibitor.

2.散熱器的冷卻液通常很熱并且有壓力。

2. The coolant of radiator is usually hot and pressurized.

不冷卻時不要清理散熱器或拆下管子，不要在風扇運轉時對散熱器進行操作或打開風扇罩。

Do not clean the radiator or remove the pipes when it is not cooled. Do not operate the radiator or open the fan cover when the fan is running.

3、外部清潔：

3. External cleaning:

在多塵或骯臟的環境中，散熱器的縫隙可能會被碎屑、昆蟲等堵塞，從而影響散熱器的效率?？梢酝ㄟ^噴灑低壓熱水和清潔劑，將蒸汽或水從散熱器前部噴向風扇，來經常清潔這些輕微的沉積物。如果從相反方向噴射，污垢只會靠近。使用此方法時，用布蓋住焦化發電機組。

In a dusty or dirty environment, the gap of the radiator may be blocked by debris, insects, etc., thus affecting the efficiency of the radiator. These slight deposits can be cleaned frequently by spraying low-pressure hot water and detergent, and spraying steam or water from the front of the radiator to the fan. If sprayed in the opposite direction, the dirt will only be close to the center. When using this method, cover the coking generator set with a cloth.

4、以上方法無法清除頑固沉積物怎么辦？

4. What if the above methods cannot remove stubborn sediments?

焦化發電機組的散熱器可以拆下來，在熱堿水中浸泡20分鐘左右，然后用熱水沖洗干凈。如果您選擇使用硬水一段時間，因為接頭漏水，或者因為發電機已經運行一段時間沒有使用除銹劑，系統可能會被水垢堵塞。

The radiator of the coking generator set can be removed, soaked in hot alkaline water for about 20 minutes, and then washed with hot water. If you choose to use hard water for a period of time, because the connector leaks, or because the generator has been running for a period of time without rust remover, the system may be blocked by scale.

所以說要定期檢查焦化發電機組的管接頭，防止漏水，并定期加水從散熱器頂部排出空氣，保持系統“無氣”。以上便是問題的介紹了，希望能給用戶帶來參考。更多內容就來網站http://m.hdlelisa.com咨詢了解！

Therefore, it is necessary to regularly check the pipe joints of the coking generator set to prevent water leakage, and regularly add water to discharge air from the top of the radiator to keep the system "airless". The above is the introduction of the problem. I hope it can bring reference to users. Come to the website for more information http://m.hdlelisa.com Consult and understand!